This video displays the steps required to replace a power cord on a Hoover WindTunnel model U5720 vacuum
Пікірлер: 16
@jmango466511 ай бұрын
This procedure was spot on. I followed along step by step and replaced the chord without any issues. Thanks for sharing Larry
@midlat247 жыл бұрын
Thank you for posting this detailed video. It made my cord replacement activity go a lot smoother. I appreciate the amount of detail that you included in the video instructions.
@matt636r8 жыл бұрын
Thank you. After watching this video, replacing the cord on our vacuum was a snap.
@JefferyADavis623 жыл бұрын
Thanks so much! Very informative. For future videos, maybe don’t shoot in landscape mode so it’s easier to view.
@stevenmartin40542 жыл бұрын
Thank you sir. I had a different model Hoover but the principle was the same.
@margaretolis2393 Жыл бұрын
Thank you so much!!
@randycummins1237 жыл бұрын
Thanks For Vid. Buddy....Allowed me to replace defective switch....
@吳佑佑-x8l2 жыл бұрын
better than expected.
@larryzuckett25989 жыл бұрын
If you are using Buchanan wire nuts, the recommendation for 1 #16 awg wire connected to another #16 awg wire is to use the small WT51 yellow wire nut. Check the table on the side of the packaging on the wire nuts.
@gregknauss66864 жыл бұрын
This bros from Pittsburgh for sure hahaha
@larryzuckett259810 жыл бұрын
Hello all, this is my first production. I am trying to figure out why I have the bands on the video. The format is 16 x 9 HD using Cyberlink Power Producer. Any suggestions would be welcomed.
@tylonbarnes96787 жыл бұрын
I did the same the WindTunnel self propelled u6432 900 and u6476 900
@chowman0073 жыл бұрын
Hi, is there a video on how to remove the motor of a hoover UH72511 model? Am having a hard time. Please advice. Thanks.
@RalphTavarez6 жыл бұрын
What if my switch has a yellow cord
@paulsypersma71652 жыл бұрын
This guy woll make you go to prison,dill into the bulkhead and get them,plug and go.Hell with tape,your own kinks.