Power flow analysis by using Matlab/Simulink

[@shayansh9339]

It was instructive, thank you:)

[@SalahAbbasTaha]

How did you calculate the voltages 10kv?

[@schneiderplcprogrammingcod1906]

Hello, thanks for the video. Please how can the PA value Bus 2 change after the load flow?

[@kamilusanusi9336]

Thank you for the video, can u explain how constant impedance load can be used in load flow analysis instead of constant power load

[@otmanwerfaly879]

Brillant !

[@abhisen6745]

Good work guys

[@spacebasedsolarpowersbspsb6548]

Very nicely explained... Do you have SVC simulink also

[@supermario2747]

Hi there it’s a nice video it was really helpful. But would you please make a video for carrying out an Optimal Power Flow study using simulink? Pay attention on showing how to make voltage-dependent loads and voltage-independent loads.

[@aniruddhtilavat1102]

How to put relay in this system

[@andresduarte5595]

I need help for my project. I pay.

[@chandug6595]

thank you

[@eng.wisammohamed]

W=2 Pi *f

[@markcardeno8290]

Also, it was unclear to me if the line impedances were in PU or in OHMs??