#Pressure

[@cristiangaleon6817]

Can i direct the line between NO and common or no

[@aatmadhardwivedi3124]

Tnx for suggesting me...... By the way made video on PID VALVE OVENTROP ..

[@controlsSystemsofficial]

Ok Sure... Thanks for your Support...

[@hp5683]

Hello, will this DPS work in suction? I want a signal to be generated when the pressure is reached below the set point and not above. Is this possible with this switch?

[@controlsSystemsofficial]

@HarshilParmar Thank you for your question. I think when we set the Pa maximum range in Differential Pressure switch, if its reach above the setpoint NO is activated , after it comes setpoint range NC will activated. in this case the Pa goes below the setpoint range no changes accrued the NC always in active.

[@HK-ll4jw]

www.beck-sensors.com/en/differential-pressure-switch-930-adjustable/

[@rashmiranjanmahapatra8769]

How can I connect a alaram if pressure is low

[@controlsSystemsofficial]

1 st Terminal is Phase, 2nd Terminal is switch position 1-2 is lower pressure, 3rd Terminal is switch position 1-3 is Higher pressure, you take wire from Terminal 2 and connect to any Lamp,buzzer are Alarm devices..

[@rashmiranjanmahapatra8769]

Can I get your phone no please

[@controlsSystemsofficial]

@@rashmiranjanmahapatra8769 what kind of problem you facing

[@HK-ll4jw]

www.beck-sensors.com/en/differential-pressure-switch-930-adjustable/