PrintNC Build Part 8: The Control Box

[@RichMenzel]

Great Job! Thanks for sharing. Any chance you could share your modified DC cover plate for the enclosure?

[@f15sim]

I feel dumb asking this, but which part *specifically* are you asking about? 🤣

[@RichMenzel]

@@f15sim The 3d printed cover you modified with the flush keystones and the GX connectors. Its referred to in the fusion design as "DC Keystone & Screw Terminals Cover" except it doesn't have the GX connector and the keystones are not flush. Thanks

[@f15sim]

@@RichMenzel This should be the right part: www.geneb.org/printnc/New-Keystone-&-Stepper-Motor-Connector-Plate-v7.3mf

[@RichMenzel]

@@f15sim Got it, Thanks

[@f15sim]

@@RichMenzel YW!

[@JohnOCFII]

Nice overview. Thanks for taking the time to share!

[@f15sim]

You're welcome!

[@michaelt126]

thanks for the video. modern switching power supplies, such as in the video, typically have overcurrent/ short circuit protection, temperature protection, etc.

[@mciarlillo]

Awesome overview of your enclosure! Did you ground the shield drain on the spindle cable to the wago ground on the VFD side?

[@f15sim]

...but the VFD may not. :)

[@f15sim]

@@mciarlillo Yes. It would suck as a ground otherwise. ;)

[@mikepowell9316]

Nice video.

[@danielsLL]

could you link where you got your cable raceway?

[@f15sim]

Here you go: www.amazon.com/dp/B081GWZTB7

[@joebifano1614]

Where can I get the Keystone faceplate and the other faceplates you have on this box. The link below is no good. Do you have another link for these?

[@f15sim]

If you're referring to the link at geneb.org, I just clicked on it and got a 2nd copy of the plate, so....

[@joebifano1614]

@@f15sim No sorry for the Printnc. You have a keystone plate and a power plate with the emergency stop and start and stop buttons. I can't find those faceplates anywhere.

[@f15sim]

Try this: www.geneb.org/printnc/printnc-lettered-panels.zip

[@memeswithoutcontext4716]

What software do you use? DCS? Are you going to use track AR (for example with META quest 3) or just a classy 3 projektor setup? Great work and projekt btw.! Love it!

[@f15sim]

You'll have to wait for an upcoming F-15 video. ;)