Problem MKS Robin nano

[@mickyovts3872]

Did you ever find out what was wrong with this, I have a similar problem on my ender 3 with the robin nano v2 board it heats up but won't actually start printing until I manually lower the extruder temp 2 degrees, done pid tuning too....

[@mickyovts3872]

Ahh just wat he'd the rest of the video and it is the exact same problem.....

[@zdenek620]

I had a similar problem on the v1.2 board. A larger hysteresis must be set there. e.g. at 10 Is there . >THERMAL_PROTECTION_HYSTERESIS 5, increase it by, for example, 10 or more.

[@sek099]

PID tuning

[@juriebouillon3317]

NEVER use mks Makerbase products because usually they do not work and no support from manufacturers.

[@zdenek620]

That's right, you're right. We wrote about the problem for a long time. When it was clear that the board was not working and would want to be replaced, they stopped communicating !! I bought BigtreeTech instead and I have no problems. MKS Macerbase was a waste of money.

[@juriebouillon3317]

@@zdenek620 You are so right. They said that i should learn how to use Marlin. All my other boards use Marlin as well and they work right out of the box. Never again will i waist time and money on any Makerbase product.

[@zdenek620]

@@juriebouillon3317 They should make better goods, according to them the buyer is responsible for everything.

[@dtteamofficial]

I know, I will NEVER make that mistake again, the extruder motor wont move. I plug it into the X header, it moves. I plug the X connector into the extruder header, IT MOVES! But the extruder wont move when in the extruder connector.