Programming mercury active trim

Programming and using Mercury active trim through vessel view

[@matty8438]

Is profile 1 for rough weather and profile 5 for calm weather?

[@shanemccormack4840]

This is what the video explains. What am I missing here

[@armansarkisian5248]

Is there an option to chose how high it can trim on any profile, or set the limit?

[@shanemccormack4840]

I don’t think I understand your question. You want to figure out the max at speed and then set it to trim that much when on level 5 and then the other lower numbers are less aggressive.

[@armansarkisian5248]

@@shanemccormack4840 my current active trim on level 1 goes all the way to 35 which is too much, trying to recalibrate it again to around 20-25, how do i do it? My question is how do i set active trim 1 to trim up to 25%?

[@wyattwelch8590]

My active trim isn’t working. I did your video. Do you still need the active trim module with vesselview?

[@shanemccormack4840]

Unless you have the new style controls with CCM built in you need the active trim module. The video I posted was after installing the active trim module, probably should have mentioned that in the video…. Sorry🚤💨

[@rustntrucks]

Hello from France I can't get my activ trim to work. The programming is proceeding normally but when I go sailing the trim don't move and after a few seconds I have an error message telling me to take the trim manually. I have a simrad GO9 with the vesselview link and a Mercury v6 225hp engine. My boat has already returned once to the seller and an update of the active trim module has been done, but without success. Do you have an idea ?

[@shanemccormack4840]

It’s possible the active trim module is not in a good spot to receive gps signal. Also could be a bad active trim module. You would need to have your local dealer plug into the SmartCraft network and check it…. Hope this helps!

[@redouanetali2374]

I there I got the same issue with my boat