Project 4R75W swap - Part 4 - Replacing bushings

[@larryschaum6280]

Looks like the front pump bushing is in backwards

[@Shawnsboostedgarage]

Will that matter? I’ve had it apart since this build and haven’t noticed any problems.

[@larryschaum6280]

@@Shawnsboostedgarage I don’t know if it would cause anything but a possible fluid leak, at the front seal. The oil groove in the bushing should open to the inside of the transmission. (Open end of groove) the closed end, should face the seal. The groove should be about center of the oil return hole in the pump. Note….the original bushing groove from Ford. Is never in the correct position.

[@Shawnsboostedgarage]

@@larryschaum6280 ok well thanks for pointing that out. So far I haven’t had any leakage issues but if I do I’ll check into that for sure.