Project Rebel: 1985 Honda Rebel Bobber Build PT. 5 (Final)

[@mayhembike]

Get cheap 2 pin LED relay from amzn for $7. If still no blink remove either the lt blue or orange wire that is in wire box up front that goes to the "indicators". It should then flash properly. The other option is resistor on each leg which I found to be a pain. I would rather not have the indicator and be done. This has worked for me on 2 of these cycles. Just make sure to tape the open wire to prevent a short.

[@cbrawr1000rr]

I wasn’t going to dig to hard into it, if I were planning to keep the bike long term I would have went LED. I picked up a vstar 650 project that I was ready to kickstart.

[@tonydarko67]

Links to blinkers and the seat?

[@cbrawr1000rr]

I just searched them on eBay, they don’t come up on my previously purchased anymore. For the seat I just looked up bobber seat and same with blinkers. Lots of options

[@spectrairsoft]

How much decibels have the straight pipe?

[@cbrawr1000rr]

No idea, it wasn’t that loud though, deft quieter than any large bore cruiser. Sounded like a coked out lawn mower.

[@mayhembike]

Link to my Rebel video with LED on all corners. kzbin.info7qR0pJoXi2E?feature=share