Proper way to connect damage coaxial/antenna cable w/out soldering

Proper way to connect damage coaxial or antenna cable without using any soldering iron! it so easy on how to manually repair cut antenna or coax cable at home without using any connectors!
Thank you for watching !
‪@SupeRheyOfficial‬

[@chiragsharma901]

PRE AND POST BIT ERROR RATE LAUGHING IN CORNER😂

[@cheehoo4467]

Never do this!!

[@SupeRheyOfficial]

Okay! Thank you 😊 ❤️ 👍

[@-8_8-]

​@@SupeRheyOfficial lol!!

[@GraduateShot06]

Bro I saw this after I did it and now my Wi-Fi’s fucked what do I do

[@cheehoo4467]

@@GraduateShot06 the Simple answer would be just get a new coax cable and ensure the connections are snug when you connect it. Splicing coax is not hard at all but it absolutely needs to be done properly. Especially if it feeds your modem. You need a compression tool and precision stripper and then buy fittings, nah. Just replace the cable.

[@kpcgkhn]

Shield must cover all outer face. If don't signal will escape from cable.

[@-8_8-]

I would bever do this with internet. But: video said antenna cable. So... Yeah, idk. If you've got the time and not the barrel, f connectors, compression connectors, and cutting tool this *might* be good enough.

[@krisyoder5129]

Now you've introduced a coil into the cable signal!!! why???

[@SupeRheyOfficial]

👍❤️

[@gackal1982]

congratulations you just exposed the conductor to interference, coak must be terminated with rg connectors and an f81 coupler

[@SupeRheyOfficial]

👍❤️

[@madmeister407]

Just buy a proper inline connector, they cost next to nothing.

[@SupeRheyOfficial]

Okay brother thanks for the advice 👍 ❤️

[@laordendelbuho7208]

Quien no lo hizo pero no sé trabaja así

[@jonathanminnis4018]

🎉

[@irishhandyman2009]

WRONG!

[@realhexsortilege]

One word. INGRESS

[@haxboi5492]

Also impedance change

[@jonathanminnis4018]

Noo

[@elmirzugor7163]

Hahahahaha

[@firstname9987]

Or you could just barrel it together this way is not good

[@SupeRheyOfficial]

Ok you had also a good idea, thank you ❤❤

[@Bmoneygothandz]

As a master tech you never do this… this cause a lot of ingress and egress signal will never be good this way just barrel it

[@mortsdans]

@@Bmoneygothandz Does this actually make a noticable issue? The wire is still shielded. The distance between the wire and the shield might be a bit off but not by too much. I would think most devices have at least some totally unshielded conductor where it meets the circuit board and it's still fine

[@joshuanapier9413]

​@mortsdans It will cause massive issues in any system that operates a two way plant.

[@-8_8-]

​@@joshuanapier9413heard! But the title of the video is "antenna wire" so I think he's running a cable to a home made antenna. So are we still worried about ingress?