PS2 Repair: Troubleshooting Common Video Issues

[@ZargayKhan-yj8tt]

I like your video .I play playstation 3 games I am Pathan from pakistan

[@axcc]

Yea, i have a backward compatible ps3 I use it all the time

[@امير-ح9ع]

you are the best 🤗

[@axcc]

It's not a problem it's a passion for electronic repair.

[@Modzie868]

Change the IC that does be near the controller cable. That is the cause of no video

[@Modzie868]

the toshiba IC

[@axcc]

@Modzie868 No, that is a different ic for the controller. What board is it?

[@axcc]

rb109 resistor ic between the ee engine and graphic chip

[@axcc]

you have to get it of another motherboard

[@alex3107-ps2]

It's the IOP RAM

[@melvinpervis6678]

Mines show but has lines running through it

[@axcc]

Check the network resistors they're bad between the cpu and GPU. Good luck finding them. I have to take them off donor boards.

[@melvinpervis6678]

@@axcc thank u I'll check for a donor board I guess

[@FastEddy5]

​@axcc, can't you just use 47ohm 0603 resistors?

[@axcc]

That is a resistor ic you can try it. I never have to i have a lot of gh-15s that are dead around

[@cj599]

I have a ps2 that has video issue maybe i could send it to you to check out

[@axcc]

I would be more than happy to if it is not a 30001r

[@cj599]

@@axcc 39001

[@cj599]

@@axcc its a 39001 i believe how can I contact you

[@axcc]

Look on my page email is there or at [e-mail]

[@pandaofnom]

I would try to get someone with a better setup. This is not an insult to him but from what I see he doesn't have a bench or other proper test/soldering equipment. With smd soldering in the ps2 you need a stable surface, esd protection, microscope and a good temperature controlled solder iron where you can set the exact temperature. This is also just my opinion so take it with a grain of salt. My experience though is that when you cheap out on your equipment you get less than desirable results. For instance when using a cheaper iron the temperature will fluctuate and cause more sold solder joints.

[@melvinpervis6678]

I could not see one thing you just did

[@axcc]

I was replacing the resistor ics between the GPU and the cpu i will make a better video

[@mohandmohand2047]

Ps2 scph 75004 black display 😢😢😢😢

[@axcc]

Check the network resistors between the GPU and cpu should be 47 ohms

[@mohandmohand2047]

the cod is 680 it is 68 ohm not 47 ohm bro

[@axcc]

I don't have a wiring diagram for a 75000 series, and I can't find one it was never released 😢

[@ZargayKhan-yj8tt]

I have ps2 scph 50000 board no GH 23 ntsc j And mod chip install M7 GP788xl Auto boot hdd

[@axcc]

That is the best of both worlds. I don't do mod chips. When they fail, they're worthless and can't find replacements anymore