Pt.4 1JZ Tune Up | How to install -AN Fittings In Valve Covers

[@Fordman7575]

It's looking good! Just a couple tips. When using the tap I like to use wheel bearing grease on them. The heavy grease catches a lot more of the shavings then oil does. And I stay away from teflon tape on the engine. I use the paste sealer. The paste is less likely to cause any issues if any of it gets in the engine. I can't wait to see you get this engine in back in your Z and hear it run in there!

[@jeffintoronto5712]

I agree that's it's a nice clean look. I like the black for the VC's rather than seeing a new colour on practical every component like some people do in their engine bay. Nice job.

[@theonlym12]

Just so you know, the collar for the an fittings are actually reverse threads. When you go to install them on the hose just apply a little pressure and a little oil and spin it on backwards. It goes on really easy. Obviously theres no threads on the hose the collar will "thread" onto it.

[@derpaderp6642]

Super Clean Brahh!

[@Kowalski401]

Nice job! It's going to look really clean.

[@StewartMotoring]

Thanks for watching!

[@predaR6]

@@StewartMotoring i love the look of it! Any reason why the 1jz and not the 2jz ? Iknow there both nice engines but just wondering 😁

[@StewartMotoring]

Preda R6 initial cost. 1jz was at least 2k cheaper

[@predaR6]

@@StewartMotoring haha oke that makes sense! That's 2k more to spend on other things

[@magnetic_5oh194]

Aye finally another vid :) Nice job so far man :)

[@gabrielalejandro1600]

what were the exact fittings needed for this? And then what length of SS line did you use per side?

[@StewartMotoring]

I said in the video. They are 10an fittings with 1/2npt threads. Thanks

[@promalachi117]

I like the vise that's not being used haha but good shit

[@RaceLifeByRicky]

what black paint is that?

[@StewartMotoring]

Just some cheap rustoleum

[@oemplus3613]

Awesome!!!

[@adnanabbas1927]

Hi my friend I want ask you about the engine mounting Where I can find it for 280zx Thenk you

[@ammoking6099]

You could just drill it out and weld on an bungs

[@StewartMotoring]

If i remember right they are magnesium valve covers. Which are not easy to weld. I couldn't weld them would have to take them to somebody

[@BUZDRIFT]

no fkn tape inside the fitting, Fuck NO!

[@StewartMotoring]

If you're ganna cry, just let me know

[@BUZDRIFT]

You're showing the incorrect method, your stuff no mine I guess! Never seen it Ever done that way except for cutting the hose, each to their own...It's Gonna BTW!