Pulling the Cobra’s Engine to Find The Damage.. IT'S BAD

Thank you for watching! Please like and subscribe

[@TreoHD]

im rooting for this channel!! i can see you getting tons of subscribers in the future!

[@nicbowen38]

Lazy Spinach hopefully when I have cars that run again I can get some subs 😂 Thank you!

[@carsandhobbies]

Dude I'm loving your content so far! Can't wait to see it back on the road

[@nicbowen38]

Cars and Hobbies thank you so much!

[@venom5oh939]

Golden stuff dude!

[@jakeadams1423]

How do u talk and present so well with like no editing of the video

[@nicbowen38]

Jake Adams there’s actually a good bit of editing out me just babbling, I just do my best to cut it smoothly 😂 At the end of the video I had just spent 9 hours pulling that engine out and my brain wasn’t functioning properly so there was a lot of editing 😂

[@SvtCobraKid1]

140,000miles and has a bent rod damn

[@nicbowen38]

Gary Bell are you saying that’s surprising, or that’s normal?

[@petrolhead8851]

That’s surprising! These motors will go over 200k miles even if you boost them and will still make healthy power if taken care of properly

[@austint.5009]

atleast there's more positives than negatives with the car. I'm currently building a new edge gt for drifting and I can't decide between turbo or supercharger

[@nicbowen38]

Austin T. Definitely turbo. I had a centrifugal on my green car and the mid range power sucked in my opinion. There are some ways you can remedy that problem, but on3’s single turbo kit is $2000 so for me it’s a no brained

[@nicbowen38]

brainer*

[@tondaporter3709]

Did you prime the oil pump and rotate the engine over by hand to get oil up in the top end?

[@fuckshit2569]

What’s your Instagram?

[@nicbowen38]

@nicbowensvt