Pulse-pause Timer surface explination

[@ArtV4ndalay]

Thanks for the video. Do you know how i can hook up a pressure switch? I want to press the switch one time and my water pump should run for X minutes. Thanks.

[@jarcum1]

ArtV4ndalay For a switch, i would put it on the positive power wire before you go into the board. That way you control when the board is activated, via whatever switch your using

[@risotoo4564]

Thanks for your video. Do you know if it's possible to set more than 60sec but less than 2min? For example, is it possible to set a 80sec delay ? If yes, how can you do that ? Thanks

[@jarcum1]

I believe it may be possible but it would be hard because you would have to switch the second to minute and you would have to find a certain point within one minute to 60 minutes to actually hit 80 seconds which would be really hard I would possibly recommend maybe a different variable style resistor and then you time the lights with a stopwatch next to it when it turns on and off there is an LED that will but you know how long

[@johnpowers253]

Can this device close a circuit 3 times with a one second interval when the ignition is switched on (and it gets 12 volts) and the go to sleep till the next time I turn the key? I want to default my car to sport mode.

[@jarcum1]

John Powers no it can't, it is to slow

[@jarcum1]

John Powers actually it may sorry I miss read the question.. are you say to close it, wait a second, then open it, wait a second and then reclose it and so on?

[@jarcum1]

John Powers I re-read your question. It can't switch between 1 second pauses to being off. It will keep going in the pulse pause you set it to when 12v is on it which would mean it would keep pulsing when you have the car on.