R32 skyline RB25DET. 2,3,4 gear pull.

R32 skyline RB25DET standard ecu, standart injectors.10psi boost with a pt76 turbocharger. 2,3,4 gear pull

[@driverS13]

i do not remember standard turbo parameters, but this is much bigger. compressor ar80 exducer ~102mm. with oem ecu there's fuel cut as well, but now i'm running nistune with z32ecu and 660 jets, still not mapped, need to replace clutch it's quite fucked up:) so you also need to map it.when i was running standard ecu engine was going almost dangerously lean in high rpms

[@roflex2]

If it runs lean you need to tune it properly, have you had the entire map retuned properly? If not then you are asking to blow it up.

[@driverS13]

yes, it is illegal run rhd car in our country, so i had to swap from rhd to lhd

[@shaun54]

The last couple rb20dets i have had reved out to 8000rpm with the factory ecu.

[@daenenham7958]

where did you find a dash to convert it???????

[@808bkt]

standard ecu lets you rev to 7k?

[@driverS13]

thats right.cut is a little over 7krpm

[@roflex2]

9500rpm if you remove the revlimiter.

[@driverS13]

this is oem r32 gts-t dash

[@jhaze918]

what kind of power is she putting down?