Rally ptg2r Lc racing

Lc racing ptg2r with centre diff

[@jamiejck]

Hello Dan. Thanks for showing my 3D printed parts. I used the original center chassis support at the front. I just cut it to length. You can use an HPI dogbone 86193 for the front center driveshaft. I pushed the 2mm pin out, drilled it out to 2.5mm. Make sure you use a sharp new drill bit. Then pushed in some 2.5mm pins. Most 2.5mm drill bits are 2.4mm so it's a nice friction fit. It works well.

[@paddlesworthrcpark8215]

Nice cheers m8

[@briandoroshuk6837]

Hey Leadfoot, is there a way to purchase your 3d parts or files? Cheers!

[@jamiejck]

@Brian Doroshuk Hello Brian. I'll let you have them. Have you fitted the centre diff yet?

[@briandoroshuk6837]

@@jamiejck LOL not yet even purchased the kit… I’m still contemplating the purchase and this rabbit hole brought me to your clever mods. So I’m just making sure the parts are available somehow if I get the kit. It just a case of rc collection = n + 1 😆

[@jamiejck]

@@briandoroshuk6837 if you do decide to do it, you will need the 3d printed parts before you start the conversion. This would make sure you drill all the holes in the right place.