RB20DET Rebuild (Part 5) Apexi Turbo Install -- 350-400bhp

[@nastystew6942]

I have the Apexi RxH6 turbo for my evo! And it's a bad ass turbo

[@ConvectionConnoisseur]

Great video. What exhaust manifold is that? Also how did you route the coolant line around the back of block?

[@ToolTimeWithTom]

From memory it's a LeadFootRacing manifold, based in the UK. Normally I use the clip that holds the hard line, open it out to remove the hard line and pop the braided line in it and close it back up

[@harper6089]

Hey man. I have this same apexi turbo I am about to put on my rb25det. Do you remember what the size of the AN fittings were for the oil/coolant into the turbo? Also would re doing the coolant line at the rear of the block be too hard to do with the engine in the car?

[@ToolTimeWithTom]

I think they're M12x1.25 but not 100% sure on that, I went with AN4 lines. Yeah will be tricky to do in the car but not impossible, there's a single M6 bolt holding the line on the back of the block, it's the clips for all the coolant lines that will be the trickiest bit

[@harper6089]

@@ToolTimeWithTom thanks for the reply and info mate, much appreciated!

[@teamshutdown8612]

Hey we're can I find all the torque specs for the rb20det

[@ToolTimeWithTom]

Have a google for "R32 engine manual" there are plenty of copies online

[@teamshutdown8612]

@@ToolTimeWithTom ok thanks I look but who do you trust for that there's a lot of BS out there

[@ToolTimeWithTom]

First search result should be the factory service manual

[@nistun3]

What rpm do you hit full boost

[@teamshutdown8612]

@@nistun3 like 7 I have a stand alone so I can set different red line points