RC4WD Limited Edition Blazer - Spring Mud Bog

The RC4WD Trail Finder 2 Limited Edition Blazer out in the spring mud.
The truck is currently built with the following:
Rc4wd Cast K44 axles
Holmes Hobbies TorqueMaster Expert 35t
Castle Creations Mamba X ESC
Savox 1210SG steering servo
Rc4wd 1.55 Falken Wildpeak A/T AT3W tires
SSD RC winch bumper
Rc4wd roof rack, rollbar, light bar combo for the Blazer
Rc4wd Tough Armor rear bumper
R3ScaleDesignz inner fenders
Futaba R203GF receiver
Rc4wd 1/10 Warn winch & wireless controller

[@shotgunrc9785]

And I complain about having to clean my truck(s) of Vancouver Island mud. Damn. That clay is brutal! A+mazing truck and video as always.

[@albertascaletruck6802]

That was some pretty bad stuff. Thanks Shotgun RC!

[@ruslyrc2415]

Mantul sangat Om...😁😁👍👍👍

[@sprather84]

Wow absolutely incredible vid my RC friend 👍 SUBBED

[@albertascaletruck6802]

Awesome, thanks for watching Sean P RC

[@kinslersrccustoms6945]

Nicely done and I loved how much you drove it like you were in it. And the truck looks great with the 1.5's on it.

[@albertascaletruck6802]

Thanks Troi! That's how I like to roll, I really like these tires too. Thanks for watching!

[@LegendaryRc]

cool run dude subbed bro

[@albertascaletruck6802]

Thanks Legendary Rc! 👍

[@brianwood9849]

BIG BALLS! Nice video.... man I just can’t pull myself together to put my blazer in that mud lol.... your blazer looked SUPER SCALE ! How do you clean it afterwards?

[@albertascaletruck6802]

Haha thanks Brian! I hosed off most of the mud but I'll admit, i needed to re-build and lube the front axle a couple days after this video because the mud worked into the bearings and dried. So i needed to soak and clean each bearing in the axle, cover them in grease and put it all together again. If i had quality bearings with rubber seals this wouldn't happen. Thanks for watching!

[@ConditionZero76]

Great Video but those tires look to small for the Big body0

[@albertascaletruck6802]

Yeah they were pretty tiny, thanks for watching HKGuy!

[@HardysHQ]

Which bumper mount did you go with for you tough armor front bumper? #1, #2 or #3? Don't want the bumper post in the way for the Steering servo Arm. Thanks