Re-webbing an aluminum framed lawn chair.

I found this chair out by the garbage can of a house in my neighborhood. Always being in the need of lawn chairs for social gatherings and opposed to just having this go to the land fill I snatched it up. In this video I'll go over the connectors I've seen used to attach the webbing to the frame as well as some pointers on how to do the job right and avoid some of the pitfalls that I wandered into.

[@plasma3211]

Thank You!! I have been searching for a concise description of how to install the dreaded T Clips! Your video is the only one of dozens that properly explains what to do. The directions that come with the webbing kit are wrong, imagine that! After fumbling with the clips I decided to go with the screws on the chair back. I didn't have a screw so I went to Ace Hardware and bought expensive screws that would fit the diameter hole-about 9/64's. I am using a Grommet kit for the webbing on the length wise. Later I realized that the screws won't work in my smaller diameter screws with those grommets! Now Im back to the clips and will make another attempt following your valuable advice! Thanks again!

[@Theoriginalmalcontentcorner]

Best of luck and well wishes for a smooth job!!

[@Nik-jr5pw]

Great video. Thanks for sharing

[@Theoriginalmalcontentcorner]

Welcome! 😁

[@matthewverando2121]

Does the 3 inch webbing actually measure 3 inches

[@Theoriginalmalcontentcorner]

Sorry for not getting back to you sooner, Matthew, but yes, it does measure 3 inches.