(REBUILDING) A 1965 C/10 Lower Control Arm - Pivot Shaft Install (How To)

[@ronbunker5778]

Thanks for taking the time to create this tutorial!

[@ACDesignsGarage]

Thank you for watching, I really appreciate it!!!!

[@JohnW1711stock]

The best part is the Made in USA, on the boxes. LOL! Nice work.

[@outragousbob4367]

Just did mine. The stock shafts and the ones I used have two recessed holes for the crossmember rivets to align with. Also the Gm shop manual calls for 140 ftlbs on the 1 5/8 nuts.

[@ACDesignsGarage]

Thanks for the info, ill check mine!!!!

[@stevencoughran6115]

Hello, nice Video thanks iam doing a 66 c 20 keep up the good job

[@ACDesignsGarage]

Awesome, thank you, good luck on your project!!!!!

[@aussiejas6599]

Great video, Did not know VW changed there suspension.

[@ACDesignsGarage]

Proto type 😆

[@angusmctavish8978]

Perfect.

[@ACDesignsGarage]

Thank you!!!!!

[@TheBigjerm408]

When do you torque the end caps ? After you put the control arm back on the frame or before

[@ACDesignsGarage]

What ever is easiest, it may be easier on the frame so you dont have to hold it. I did it in my vice and it was tough to hold.

[@aussiejas6599]

FURST..!

[@ACDesignsGarage]

thanks for the support!!!!!

[@SamuelHarris-l7e]

Can you change the a arm bushing while still on the truck

[@ACDesignsGarage]

I think you could, it may be a little tougher!!!!

[@NEWMANPRODUCTIONSTV]

Where did you buy the lower control arm?

[@ACDesignsGarage]

Those were the original ones off the 65

[@NEWMANPRODUCTIONSTV]

@@ACDesignsGarage Thanks

[@terrybigchopzguest]

i have a 60 c10 looking for someone to put in a big back window panel for me

[@terrybigchopzguest]

what part of NC you at

[@ACDesignsGarage]

Mooresville