Thanks for taking the time to make tutorials. I’m new to the controller party and they are very helpful.
@ReefAndReptileAutomation2 жыл бұрын
Glad to help!
@emmanuelperez48302 жыл бұрын
Love these short videos
@ReefAndReptileAutomation2 жыл бұрын
As do I :)
@Lucas-coral-reefs2 жыл бұрын
Let’s give a like to our favorite tech genius for the first true LSS review, still deciding if I really want one yet lol
@ReefAndReptileAutomation2 жыл бұрын
Thank you so much!
@russmichel53312 жыл бұрын
A few clarifications: Not covered in the video, but the LLS Initial Setup Task in Fusion is the fastest, easiest way to setup a new LLS. The units can be set to either inches or centimeters in the FMM module configuration. This is a global setting - set it for one FMM, it is applied to all FMMs (just like you can set LPH or GPH for flow sensors) The white eTape is made with a tough polymer which is chemical resistant; the tube is not acrylic - it's polycarbonate. The LLS can be cleaned with vinegar/water mix or citric acid.
@ReefAndReptileAutomation2 жыл бұрын
Thanks Russ!
@Theaquaplex Жыл бұрын
Any updates on this thing? My range is not accepted even though I am following the directions to the tee both in automatic calibration and manual calibration. The readings are off... 6" is reading 69.5 and fluctuates alot...then time out on the calibration.
@ReefAndReptileAutomation10 ай бұрын
Still have not installed these. Find them rather silly TBH.
@OCReventsAndbuilds2 жыл бұрын
❤️
@ReefAndReptileAutomation2 жыл бұрын
Love ya to
@bobjoachim97103 ай бұрын
Hey sir would be down to help me with some programming
@ReefAndReptileAutomation3 ай бұрын
I do not assist with programming on KZbin tube. Try our Facebook group.
@jasonkelsey3868 Жыл бұрын
Range acceptable won’t turn green for me
@ReefAndReptileAutomation Жыл бұрын
SORRY IT TOOK SO LONG. I must have not had notifications turned on! Not sure what this means exactly. I stopped using them cause they were a little finicky.