Removing shaft and bearings from output end of brush hog gearbox

Рет қаралды 75,591

Күн бұрын

This video explains the method I used to remove the output shaft and bearings from an RC-30 Omni style brush hog gear box. This gear sits on a bobcat brush hog, but is of similar style to many of the brush hog gear boxes out there.

Пікірлер: 15

@sweetpigfarm3645 3 жыл бұрын

Thank you! This got me thinking and I used an old brake rotor as your 2x4 and 2x4s as the spacer. Mine was rusted inside and it took a lot to get out then a few taps. For the back bearing I used the greasy rag trick. I punched pieces of a greasy rag into the center of the rear bearing and it pushed it out. Thanks again! This what youtube is for!

@RayofallTrades 4 жыл бұрын

I owe you an apology and thank you! I thought my puller and tools would work better so I spent 3 hours and 2 bandaids later to finally give up. Then I built your puller and 5 minutes later I was done! Thank you!!!!!

@ToddSmith-fr7hy Жыл бұрын

Good video. Thanks

@Glens1965 2 жыл бұрын

Very clever!

@danielseelhorst2464 5 жыл бұрын

How did you get the retaining clip out?

@mpberge 5 жыл бұрын

I think I wedged a screwdriver to pin one side and kept it from spinning and used a second one to work the retaining clip off. Now that you mention it, I recall it being a pain.

@David.-_- 6 жыл бұрын

Where did you buy replacment gears?

@mpberge 6 жыл бұрын

David, www.ranch-rite.com/farm-agriculture/gearbox-parts.html has gears for the Omni style gear cases.

@georgesimillides3689 6 жыл бұрын

Can you please give details where to get new gears?

@mpberge 6 жыл бұрын

George, I purchased these from www.ranch-rite.com/farm-agriculture/gearbox-parts.html.

@ScottyHisdahl Ай бұрын

HOW DO I GET THE GEAR BOX OFF?

@mpberge 10 күн бұрын

You got to remove the blades first. Then remove the shear pin that connects the hydraulic pump to the gear box. Then remove the 4 bolts that typically hold the gear box to the frame.