Рет қаралды 133,556
- Remove the lid of the blind drawer. The cover will be fastened to the wall with gaskets or screwed.
- Remove the old tapes (fastening strips) from the last slat to the metal axis of the shutter.
- Clean the blind. Cleans every layer of dust or accumulated dirt.
- Remove the roller shutter with a screwdriver. Save the screws.
- Release the tape from the anchor point. If it is tightly joined, pull it with a pair of pliers to remove it.
- Unroll the entire belt of the blind by pulling from the shaft (top part of the shaft).
- Check the position of the axis with a level. If it is uneven, it can cause a failure when rolling the shutter.
- Remove the axle from the blind drawer. Clean it and remove the tape on the anchor you have on the shaft roller. To remove the tape, you must cut it if you are going to put new tape.
- Place some new supports with bearing. Screw them in the same place as the old ones, so as not to lose the axis level.
Affiliate links:
Plastic blinds discs. amzn.to/2E7QGoI
Blind spare parts: amzn.to/2VYn6MD
Rolling shutter disk: https: //amzn.to/2Hm2hRQ
Music library of KZbin:
Synergy
Invisible