Replacing front wing on a Ford Fiesta 1.2 Zetec.

Ford Fiesta 2014, 1.2 Zetec replacing front wing, it's not bad it was a little bit fiddly.

[@FMFGUF]

Useful video, thanks. I found that using a slide hammer was required to pull that last piece of the wing out from behind the quarterlight glass; there is a 10mm bolt behind it (which traps a small piece of the wing as you pull it out).

[@under5kcars216]

Thanks my friend the guy at the Ford place I use did say they can be tricky.

[@a_stringa]

How long did it take to replace?

[@reallyunimportant]

Hero, thanks for the video. Really helped me prepare for the job 👍

[@Flappyduck22]

That was very useful, I think I may tackle the wife's fiesta now. Thanks.

[@under5kcars216]

Give it a go my friend.

[@mrt9031]

Kudos to you..helps others 👍

[@a_stringa]

How long did it take to replace?

[@under5kcars216]

Took a couple of hours as was the first time I have changed one. I hope the vid helps.

[@a_stringa]

@@under5kcars216 the vid helped mate. One wing successfully changed.

[@under5kcars216]

Pukka@@a_stringa

[@mattb6542]

I ended up cutting that bit off the wing.

[@under5kcars216]

It is a bit awkward.

[@MrScottydog1973]

Think it would be a lot easier to paint the wing before you put it on the car

[@boxersjourney6441]

I think you're probably right my friend, did it a bit back to front, it was the first one I have done wasn't sure what I was doing and would of probably scratch the wing if painted. And to top it off the paint match was terrible when I finally did paint it

[@62martin-Bozkurt]

Why would ford make it so bloody hard 😡

[@under5kcars216]

Agree it's a bit of a silly design.