This is a short version of how to replace injector cups and the tools needed on a d12 liter Volvo truck THE TOOL NEEDED IS BY KTC VOL1516 Volvo sleeve remover and installer,it comes in a 4 piece kit
Пікірлер: 13
@alhoot727 Жыл бұрын
The tool needed for this job is a kit by KTC Vol1516
@hermantoofa1868 Жыл бұрын
Hi bro, this is the same tools for TAD 734 GE?
@johanpeters55284 ай бұрын
The tool for the d12 and 16 are the same?
@alhoot7274 ай бұрын
I am not sure I have never been inside a 16
@vityok3000 Жыл бұрын
Can you use old injectors again?
@alhoot727 Жыл бұрын
Yes for sure I always due unless I have a misfire. Just get a complete set of 0-rings and replace them, you won't use all they give you.. Just make sure they are in the "Right groove" When you install, there are grooves that the ring fits but there are also empty grooves,.just be sure! Wrong grooves or the ring is not good. just compare it with the old one.
@hermantoofa1868 Жыл бұрын
Hi bro, do you know the references of the tool to remove injector sleeves of volvo motor TAD 534 GE?
@alhoot727 Жыл бұрын
Sorry but I am only familiar with the d12 and 13-liter volvo ,
@klaromio Жыл бұрын
How do you know the piston is not at the top? Thanks
@alhoot727 Жыл бұрын
Take a long skinning philips screw driver and stick it down the injector hole ,you need to be down a couple inches to be safe