Replacing TFI module on a 1986 Ford Bronco II

This is a 1986 Ford bronco II XLT with the 2.9 L V6 equipped with the five-speed Mazda manual and transfer case for 2 to 4 wheel. Today I replaced the TFI module, the reason behind replacing this part was because I was having ignition trouble this is a massive part when it comes to these trucks because it always overheated every 15 min. Typically most guys would say you need a TFI module socket in this case I used a 7/32 craftsman socket with a quarter inch ratchet I had no trouble taking out the two screws I laid on top of the truck above it. Therefore it made it very easy for me to take care of the job.Do not drop the screws they are important. Now when taking off the original TFI module I would sand down the area on the back of the distributor and replace it with a heat absorbing on paste on your TFI module. Your AutoZone should carry it. For me this was a super easy swap about $60 well worth it if it fixes your problem!! Thanks

[@jamesprice6381]

McCulley racing in Cally has a RE-POSITION KIT for the MODULE its AWESOME!

[@alkoweski3765]

Bro! I bought that fackin tool, its a star bit...couldn't see back there, Google it, found your video.. its a facking 7/32...thank my lord and savior, Bill Murray, for you my dude! Easy peasy when you know the right tool...you the man!

[@scuffedgarage8519]

Right on! No problem

[@Chadhill-s4g]

How does that thing come out?

[@unheavenlyfather5463]

I was getting spark to my 87 bronco 2 but had a high idling issue, I then swapped intakes(attempt to fix the idle) and turned it over but this time no spark, I have yet to figure it out. Any advice?

[@maxromero11]

Try cleaning the idle air control valve it fixed the idle in my 2.9l ford

[@rumblertag1419]

Do you still have this vehicle I have an 87 and need detail pictures of the engine bay wiring harness

[@joshdenham8404]

I can only get a socket to grab one of the tfi bolts!! Why dont they put the dizzy in the front like every other Ford lol

[@scuffedgarage8519]

Lol you’ll get it I used a real low profile 1/4” ratchet and socket good luck!

[@ronnieking1025]

why didnt you sow the installation num nuts

[@scuffedgarage8519]

Show* and it’s self explanatory dumbo

[@cheryl9596]

This was zero help!!!!!! You didn't show what you did. WTF!!!