Replacing the Hot Air Heating Element on the 6180 Mini-Fuzer

If the welder is not getting hot and the temperature readout has a low number starting with a zero that doesn’t increase, the welder’s heating element is burned out. The heating element can be replaced by opening the handle, desoldering the burned-out element from the board, and resoldering a new element in. This video shows the replacement process.
6180 product information (multiple languages): www.polyvance.com/6180-info
Vídeo en Español: • Sustitución del elemen...
Vídeo em Português: • Troca do elemento aque...
⚠️ Important ⚠️
- Always wear proper safety gear while working!
- The length of this video is in no way representative of the actual time required to perform a complete repair and therefore should not be used for estimating purposes.
✅ SUBSCRIBE to our channel for updates on our products and tutorials!
🌐 VISIT us at www.polyvance.com
📧 EMAIL us at [e-mail]
📞 CALL us at 1-800-633-3047
✉️ SIGN UP for our email newsletter at omniform1.com/forms/v1/landin...
👍 Follow us on social media:
- Facebook: / polyvance
- Instagram: / polyvanceofficial
- TikTok: / polyvance
- LinkedIn: / polyvance
Browse our products:
- Best sellers: www.polyvance.com/Best-Sellers/
- Newest products: www.polyvance.com/New-Products/
Check out Polyvance's plastic welders and welding rod:
- Nitrogen welders: www.polyvance.com/Nitrogen-We...
- Hot air welders: www.polyvance.com/Hot-Air-Wel...
- Airless welders: www.polyvance.com/Airless-Wel...
- Plastic welding rod: www.polyvance.com/Welding-Rod...
Music © Polyvance

[@azurdo1948]

Any advice how to pre drill screws into polyethylene tank to install a pump

[@polyvance]

Drill pilot holes and use rubber washers between the screws and the tank.

[@azurdo1948]

Appreciate the advice a lot