Review Holzfforma G660 for Milling

#smallbusiness #logging #SawmillI've
been using this chainsaw for more than a year and it looks like its a good fit for chainsawmills under 48inch , ...small problems here and there , but overall its a good chainsaw for the money .
CHECK OUT MORE MILLING VIDEOS!
• This Walnut was someon...
• Adventures on a chains...
• SlabSaving 48inch Waln...

[@vetwood]

Wouldn't you prefer a more powerful model? holzforma g888?

[@Cutting-with-Paul]

I would , but it i can not get it in Romania at the moment. I am looking at a ussed ms880 , but have to change all bars and chains

[@vetwood]

@@Cutting-with-Paul you can use 3/8 chain with 880, I wonder about buying holzfforma 880 to my Stihl 60" bar

[@Cutting-with-Paul]

@@vetwood the gb bar is 3/8 with 1.3 mm .... so i have to get a new one . I would get 150cm 3/8 or 404 with 1.6mm

[@Cutting-with-Paul]

@@vetwood si 3/8 1.6 tooth smaller then 404 1.6 ???

[@vetwood]

​@@Cutting-with-Paul3/8 is physically thinner, milling is slower, but the loss of material is lower