Reviewing of AC 220V 2000W SCR Voltage Regulator Dimming Dimmers Speed Controller UPDATED 2021

Reviewing of AC 220V 2000W SCR Voltage Regulator Dimming Dimmers Speed Controller Thermostat UPDATED 2021
AC 220V 2000W SCR Voltage Regulator Dimming Dimmers Speed Controller Thermostat
AC 220V 2000W BTA16 600V AC Motor Speed Controller Dimmer
Connect this device with lamp or home appliance in a series connection, then rotate the knob for dimming, speed, voltage, temperature control.
• Applicable Appliance: Electric furnace, water heater, lamps, small motor, electric iron. etc
• Input Voltage: 220V
• Maximum Power: 2000W
• Adjustable Voltage: 50-220V AC
• Material: Plastic, metal
www.aliexpress...
WARNING:
This video is for demonstration and education purpose only. Each demonstration presents risk and hazards that must be fully understood before attempting.
And should be performed only by professionals
Disclaimer:
The information, demonstration and any content contained in this video is for informational purposes only. PLEASE READ Warning… do this at your own risk. I am not responsible for what you do to your device.
MUSIC:
Track title: Kurt
From: KZbin Audio library
IMAGE:
Quranic Dua #35 (Surah al-Ahqaf)
From: quranicquotes....
I have approval from the site quranicquotes.com to use the images

[@Presso99]

Silence is the killer, even though it doesn't have the voice, the action is very well presented, thank you

[@SalvaBarkuti]

Nice video. It can be clearly seen the variable resistance effect in hot wire bulbs. The current input at the bulb drops noticeably as the measured voltage approaches 230V, in a surprising way to me. Less than 0.15A at 230V is not even 35W, I wonder if that is a 40W rated bulb (?). Concerning the fan thing, I doubt the module will last long driving such a load, as it is inductive. In the past I used a couple of these modules to control a small multitool (a “dremel” type machine), only to learn these thyristor based regulators can't cope with such a thing for long (inductive load harmonics triggering the triac when voltage waveform not in zero, I was told).

[@LEQSBeaprofessional]

The bulb that I used in this video is 100 watts, and for using this module with the fan, I only tested it and did not turn it on for a long time

[@vendelkiss3460]

thanks correct drawing, correct component data sheet, correct connection, informative video

[@LEQSBeaprofessional]

Thank you so much 🌹❤️🌷

[@HaMoOoDiE462]

Thank you very much for your demonstration, I've already bought and installed one, I took a power socket along with electric cord with heavy duty plug, so I could use my power tools easily, but although all the above mentioned items are tightly connected and isolated from end to end, and I didn't see any arching, I still hear buzzing sound coming from the voltage controller/regulator, my question is, is this normal, and safe, or the buzzing sound indicating a hazard/risk, please do let me know Thanks again

[@oguzhannazlim]

But the LED lamp that I use to operate the module I installed is constantly blinking except for high and low levels.

[@mohammadsherali]

I see in this circuit capacitor number is 104j630 mention but find a circuit diagram from internet there is mention 400v capacitor. If my capacitor is damage then which capacitor I buy 104j400v or 104j630? Please answer me.

[@LEQSBeaprofessional]

0.1UF 400Volt = 104j400V

[@YashYash-nr1cg]

If I give it an input of 210 to 250 volts, which keeps changing, will the output voltage remain constant?

[@JEZPP]

Great music by the way. I have a question. How would you connect an illuminated rocker switch with this to control a fan. Normally the switch would be on the hot side with the 3rd terminal connected to neutral. But will the light on the switch still work when the fan is at low speed or will it work at all? How exactly would you wire it?

[@doogeey6mluca421]

in addition to the knob that regulates the power, there is also a small blue screw trimmer. Can you tell what it is for? if we can act with the hunter on that little blue trimmer? what is it for?

[@LEQSBeaprofessional]

Adjust the voltage range

[@abousamah1967]

Very very nice jop Also your scheme is very good

[@LEQSBeaprofessional]

thank you so much

[@gedreillyhomestead6926]

I have seen so many different wirings of this same speed controller, does it matter which terminal the live and neutral wires are connected to? I have seen it - LNNL, NLLN, and LNLN ! Confused! 😕

[@LEQSBeaprofessional]

Only the input and output connections of this module must be taken into account.. and the arrangement between the live and neutral wires does not matter because it is AC voltage.

[@stromshadow1942]

Can I use it for electric stove and electric kettle 1500W?

[@medelanareta948]

Same question but with 1500w deep fryer, hope you can answer

[@LEQSBeaprofessional]

According to the datasheet of this module the Input Voltage: 220V & maximum power 2000W, MAX 8A, but you must be careful whether the heating element can work on a small volt or different voltages, or will this heater be damaged ... You must refer to the technical specifications of the heating element.

[@LEQSBeaprofessional]

@@medelanareta948 According to the datasheet of this module the Input Voltage: 220V & maximum power 2000W, MAX 8A, but you must be careful whether the heating element can work on a small volt or different voltages, or will this heater be damaged ... You must refer to the technical specifications of the heating element.

[@joseguevara184]

Nice thanks. I received one but does not lower or dim anything. Is the same voltage from line to line out. Is the Triac burned? I want it for a small 24 Dc motor and a small saw disk to reduce speed. I also checked it is up to 30A as I use a 24V 15 amps power source. Please answer me if you can. Bye , good luck from south america.

[@LEQSBeaprofessional]

This circuit operates on the following data only : • Input Voltage: 220V • Maximum Power: 2000W • Adjustable Voltage: 50-220V AC for AC voltage only

[@joseguevara184]

@@LEQSBeaprofessional Thanks. Let me update. I was lowering voltage from AC to DC, that was the problem. As soon as I thought of that I applied the potentiometer to my home vacuum and worked perfectly, from OFF to full speed.

[@worldsamazingfacts8046]

Verry nice

[@worldsamazingfacts8046]

Keep it up

[@DiGiTAL_S80]

is it possible to input 12v dc instead of 220v for controlling 12v fans?

[@LEQSBeaprofessional]

@DiGiTAL Not possible

[@mdfaisal216]

can i use it with keenwood fp920 multipro food processor motor as its been damagd

[@mosaadfayez7249]

شغل ممتاز

[@LEQSBeaprofessional]

حبيبي يا هندسة. ❤️❤️

[@rickbran7541]

Can i use it in a 110v 300w mug sublimation heater?

[@LEQSBeaprofessional]

According to the datasheet of this module the Input Voltage: 220V & maximum power 2000W, MAX 8A Unfortunately, I did not test it at 110 volts

[@potchmoto4888]

This is nice Very Good

[@LEQSBeaprofessional]

Thank you so much 🌹🌹🌹

[@potchmoto4888]

Thanks GODBLESS

[@mohammadsherali]

What is the capacitor number and voltage in this circuit ?

[@LEQSBeaprofessional]

0.1UF 400Volt = 104j400V

[@mohammadsherali]

In this circuit use one 100 ohm resistance which is 5 color ban between 2 capacitors. But I know that how much watt this resistance? Because I have 100 ohm,power rating 0.25watt and maximum current 50mA and same as 5 color. Can I use this in this circuit?

[@LEQSBeaprofessional]

Use 100 ohm 1 watt

[@strsljen8686]

My regulator is broken, the potentiometer does not work but it is correct, it shows me the same voltage 220v at the input and output. What could be the problem? Please help

[@LEQSBeaprofessional]

I think the reason is the capacitor connected to the TRIAC gate via Diac because the TRIAC gate controls the load current by the voltage applied to it which depends on the charging time of that capacitor through the variable resistance. So check this capacitor firstly. If the problem is not resolved, check the TRIAC.

[@strsljen8686]

@@LEQSBeaprofessional thank you for quick answer 😀

[@LEQSBeaprofessional]

@@strsljen8686 you’re welcome

[@waltervaldivia2399]

Important question, the equipment that I use with this device loses power when using it in regulation?

[@LEQSBeaprofessional]

Could you explain more?

[@waltervaldivia2399]

@LEQS - Be a professional OK, if you connect a motor that turns at 3500 rpm with a power of one horsepower, when using the Dimmer and you turn it at about 1500 rpm, that motor always has that horsepower at that velocity? That is my question.

[@LEQSBeaprofessional]

@@waltervaldivia2399 According to the TRIAC’s work theory, as it cuts the current, so it controls the load current and thus the power which controlled by the voltage applied to the TRIAC gate, which depends on the charging time of the capacitor through the variable resistance. What I mean is that the TRIAC controls the load current and thus controls the power.

[@waltervaldivia2399]

Now I have it, in short it means that at less speed, less power. Thanks !

[@mohammadsherali]

In this circuit when I touch tester in potentiometer an heat sink then tester is glow. Why body current flow in potentiometer and heat sink also? I don't know it's problem or normal please answer me.

[@mohammadsherali]

One more problem: when input voltage 220 then I output voltage checked 200v I didn't find why 20-25V droppe in this circuit. Please answer me brother.

[@LEQSBeaprofessional]

I think that if you stand on an isolated floor, the tester will not light and it is better to use a Voltmeter to make sure of it

[@LEQSBeaprofessional]

@@mohammadsherali According to the TRIAC’s work theory, as it cuts the current, so it controls the load current and thus the power which controlled by the voltage applied to the TRIAC gate, which depends on the charging time of the capacitor through the variable resistance. What I mean is that the TRIAC controls the load current and thus controls the power.

[@worldsamazingfacts8046]

Ye kit achha hai ki nahi ??

[@LEQSBeaprofessional]

Good

[@mdfaisal216]

we do not need music

[@hvsgamex9782]

Sir can you give us circuit diagram of this

[@kumartechnicalkt5065]

Im use hot air gon

[@rubelsk2478]

Smd blower?

[@worldsamazingfacts8046]

Please Use your voice

[@harunshaikhhashmi7975]

2000 watt ki hiting bhi kavr hongi kya

[@LEQSBeaprofessional]

According to the datasheet of this card 2000W, MAX 8A

[@hustlaz2k]

FYI that is not scr... it is triac!

[@LEQSBeaprofessional]

If you see the scimatic diagram inside this video, you will notice that it contain TRIAC not SCR, but I wrote SCR, because that is the name on the link of purchase

[@waqarjan4265]

Steplizer tunning this dimmer

[@rajendrarajwade5700]

No

[@nemocap2958]

Hi,can I use this to reduce power of 900W heating element?

[@LEQSBeaprofessional]

According to the datasheet of this module maximum power 2000W, MAX 8A ... Yes, you can reduce the power

[@absalam6153]

Yes