Revit adaptive family - A curved bridge with voids

[@aleksplamenov]

Nice tutorial. Just to add some info from my experience. There is kind of issue with bridges in Revit. Because bridge geometry is mostly in horizontal and vertical curves, we are using adaptive family as you show. But If you want to make section in random position it is impossible :D It is snapping profile geometry from the beginning of the path. Anyways this can be avoided by creating multiple solids and splitting them where you want section. Another issue is when you want to reinforce it. If you place rebar in vertical curve-you can not anotate it and then you need some manual work.

[@EngineerBear90]

Hey Aleksandar! Thank you for your feedback ☺

[@candalserendipitero3626]

Hi! Nice video but as others said in the comments the video is maybe too fast and there are several minor details that are overlooked. For instance. At min 3:30 you create the spline selecting the ref points with a selection box. If instead I click over the two lower points, when it creates the spline passing by the 3 lower points it says "the geometry does not define a plane". Following your video with the selection box it does not give the warning, but why? Does it change something in selecting the points by clicking on them instead of selecting them with a selection box?

[@EngineerBear90]

Hi! Thank you! Yeah! I will adjust the speed on my next bridge video. Thanks for the feedback. It should give the same result by selecting them one by one and select them with a selection box.

[@candalserendipitero3626]

@@EngineerBear90 Hi! I tried again today and I noticed that when clicking on a point it changes the shown plane...it select a weird or horizontal inclined plane that I don't get if i select them with the selection box. Is there a way to prevent this change of plane upon the point selection? Because i if then click on the Front plane to set the previous plane it does not work, it gives the warning. The only solution at the moment is to Undo and avoid to change the plane in the spline tracking process.

[@EngineerBear90]

@@candalserendipitero3626 Hello! Not sure what the problem here is! Could you send me an E-mail with some picture?

[@candalserendipitero3626]

@@EngineerBear90 Hi! I just saw your other video with the curved box girder bridge with varying height and around 7:04 you have the same warning. However it does not seem to be a problem because you have no problem afterwards.

[@EngineerBear90]

@@candalserendipitero3626 Great it worked out!

[@ayouub831]

Thanks very much

[@EngineerBear90]

You are welcome :)

[@shuklaashish57]

nice

[@EngineerBear90]

Thanks

[@vijaypandiyan8592]

Go slow and your speaking fast and voice also low... beginners won't understand if you are going too fast

[@EngineerBear90]

Thank you for your feedback! Will adjust. Worth mentioning, this is the last video I edited on hitfilm express before switching to DaVinci, hopefully the new videos have a little better sound quality.