Revit Tutorial - Folding Door (Parametric Family)

[@shebinjawahar1]

thanks a lot maam, you are awesome . at first i had a confusion between ref plane & ref line . in the second attempt , i carefully watched the video again and done the ref plane n ref line correctly . kudos to you

[@georgeziffo6412]

Great tutorial, thanks

[@famgroeger]

thank you for this tutorial. it was very useful for me to learn the concept of making families. for me the speed of showing could be slower. it helps when your comments are in context to what you are showing/doing. i got mixed up with refplanes and lines a lot. but at the end the difference between them was one thing i learned with this video ... all the best Michael

[@LC-nw2co]

Great tutorial! Thank you!

[@locolegs1000]

It's very good. Thanks!

[@garthcarnell5420]

how did you get your sweep to the center of the wall?

[@warunijayasinghe8854]

is there a way to change the number of panels? the panel count

[@arquitectorais4651]

Is it possible to make one door panel as a family and then repeat it?

[@anasssaddane1475]

Awesome !! Very helpful

[@taimursohail1723]

Mám how u drive this formula 40mm*sin (angle). W Can u plz explain 40 mm from where u got. Why it is not width of panel*sinangle

[@LetsRevit]

40mm is basically the thickness of the panel. For this formula we needed the thickness not the width of the panel.

[@taimursohail1723]

@@LetsRevit today again I tried and made this family after seeing your video again and again with concept. Thanks for your valuable knowledge plz keep sharing and don't make this video private

[@iftekharkhan8879]

Hi mam ..why u place three references plane at r.h.s at 5.20

[@tiffanytan557]

placeholders to count for the panel thickness at an angle

[@thadyjuinio9916]

best tutorial !!

[@sayanbanerjee8727]

Please make a vedio on parametric shutter door

[@thameezgamer6332]

I can't use formula it's showing as following is not a parameter width note that parametric names are case sensitive do u know the reason...?

[@hady_hesham]

Thanks for this awesome tutorial. However, when placing angle=0 and traying to increase it again all the 4 reference lines connect to each other and leave the reference plane connected to them

[@emiliosabry]

the same thing happened to me, can't make it right

[@ribeeshtj4796]

GREAT

[@pmshihas]

Rocket science is simple than it ....

[@WibuTeknik]

02:46 ?

[@LetsRevit]

Yes. Can you elaborate the issue which you are facing at this step?

[@taimursohail1723]

Salam to u Madam, mujay ko to ab meri education per shak honey laga hai, that really I am educated?

[@sohail3360]

👍