Reviving my Buell: A DIY Motorcycle Rebuild - Reassembly Part 2

[@thirdgearboogie2210]

Good Work!

[@Ed-ty1kr]

My throttle cables works best routed together from the throttle down along or parallel to the right fork tube on the outside as if allowed to hang which will naturally follow the right fork leg with gravity pulling it down, then behind the headlight rested on top of the lower headlight up/down adjustment brackett, then turned in between the forks next to the left fork as it goes perpendicular to left forks leg and rested on top of the lower triple clamp, and finally below the frame next to the air intake following the wire harness, on it's way to the throttle body. It is not zip tied or clamped anywhere along its path, loosely routed with reasonable wiggle room so as not to cause binding or restriction... Hope it helps.

[@whiskeytangosix551]

Music was playing whlle you wer talkn

[@kz6fittycent]

@@whiskeytangosix551 yep that was on purpose! Thanks for watching!

[@iTEHb]

good job=)

[@kz6fittycent]

Thanks! It's great to be at this point finally!

[@mikelowary8466]

Atta boy

[@kz6fittycent]

Thanks dude!

[@zero_gear]

Haven’t seen and update. Everything go good?

[@kz6fittycent]

@@zero_gear kzbin.info-IbMS6aU1Rk?si=twbarSOkhNFqDO6t