RFID Access Control With Electro Magnetic EM Lock

For Business Enquiries or Support, Please Contact Us by Phone or Whatsapp to Mb: 81687 38109 or email to [e-mail]

[@travelerpunjabi2221]

How to make RFID duplicate card

[@mycrazyworld101]

Can it be used with Shop shutters

[@paigem]

So my question is can i remove cards without having them? say i lose the card? or have given one out and they lose it. can i remove the card from system without having the card?

[@jorgepadilla6426]

educational, but if pressing bthe button kindly press only by fingers only,not your whole palm covering the numbers,

[@johnaaroncustodio9238]

What wire size/gauge did you use my friend?

[@MiddleBencher1989]

Normally awg20 belden 4 pair and for network cat 5 or cat 6

[@sonu6058]

power supply kitne amp ki chaiye

[@channalone3995]

Can you send me a manual of this device .

[@louietrovela7995]

Hello, i have the same unit as you. i accidentally change the default admin password of the device and i forget it. is there anyway that i can reset the admin password.

[@StuAndSara]

+Louie Trovela - YES there is. Power off and take the back off the unit. Move the S16 or J16 jumper on the PCB from pins 1 and 2 to pins 2 and 3. Then power up, wait for 3 beeps, then power off. Wait 3 seconds and Then power on again. After 3 beeps pull the jumper off pins 2 and 3 (with power still on!) and put it back to pins 1 and 2. The master code is now reset back to default. Hope that helps.

[@projectiontv5809]

+StuAndSara I have the same problem but I'm not very experienced.. Can you tell me what a 'jumper' is? Thank you!