Rhino 6 and Grasshopper Dome with Connections Overview Lesson

[@guylemaire2995]

Hello thanks . Question : is it possible to replace the edges by meshes and how to do this ?

[@riccardosabbadini359]

i might have a stupid problem, but i dont know how to fix it, when i move all the quadrant edges to extrude them and make them 3-d; only the section corresponding to the 'x Axis' used to create the arc will move as written in the code, all the other part move on the z axis

[@DCOParametric]

I'm not sure I follow your issue, but if you don't find a solution send me a message. Copetedavid.com if you send me your script I can help you

[@조혜정-m1f]

Can I ask one question? I don't know why I can't connect two lines which are EN & Ei in the brep edges to one curve in the curve middle.. I can only connect one by one -> (1) En brep edges to (1) curve in curve middle.

[@DCOParametric]

I can help you with this, please send me an email to [e-mail] and I can help you further

[@yayaaakk]

thanks you so much sir

[@unplu6]

THANKS SO MUCH FOR THIS! DO YOU OFFER COURSES?

[@lacorteimperia6886]

May I ask why are you multiplying by 12 at the beggining?

[@DCOParametric]

to change the units from inches to feet on the slider, even if the file units is inches. So its a unit conversion from inches to feet. I hope that explains it. If not let me know, this is something I can explain in a video.