Rick Vrielijnck Instruction for M17 and PGS Servos

Top and smart driver Rick Vrielijnck instruct how to set up M17 and PGS Servos.

[@maurofanni5354]

hi, i need a suggestion. I bought a Power HD S35 servo that claims compatibility with Sanwa's SSL and PGS systems. I connected the servo to the USB port of my M17, but the radio does not notice the connected servo. what can I do?? thank you in advance.

[@quanttrader7055]

Thanks a lot, Rick. This is really helpful. I have a question related to how the sanwa PGS servo and a non-sanwa ESC should be connected to the receiver if I wanted to use SSL to set up the servo remotely. Do they both need to be connected to the SSL port via the Y-wire? Or can I connect the servo to the SSL port directly and connect the ESC to channel 2 as usual, will this work fine? Thank you for helping us with the hobby.

[@CharlesDRACOULIDES]

Can you make à vidéo for setup AUX ? Why il get range -100 to 100 ?

[@gameonly1549]

Hai, did u ever made a vidio about, setup m17 for using gyro om mixing. Thx

[@dproject2320]

i have problem with noise on sanwa pgs lh2 sxr new open box is veri noise

[@bob6168able]

Hello, I purchased Transmitter Sanawa M 12S RS. I connected it to the Receiver RX482. The steering servo is only working, but the Throttle not working. The ESC keep on blinking. Do you recommend certain procedure? Also how I can unbind the RX from the TX to bind it again in a trial to work the Throttle? Is it ok to use RX482 for for 1/8 buggy? , or only for drifting? What is the Sanwa TX recommended for buggy to give good range ? Thank you