Love the vids! Good audio quality! Giving camarata vibes in the videos now!
@DAS-Videos8 ай бұрын
Thanks! I watch AC, that's where I first saw one of these relatively cheap mini excavators 🙂
@bigwheelsturning5 ай бұрын
I was looking at one just like that on Amazon today. Is that where you got it??? 90mm wide, and 90mm between the bolt holes? Would like one with a tooth that can be changed, but I just need it to dig up small roots that are growing in my garden beds from the trees that found out that I water and fertilize. Will use it on my little Kumatsu PC02-1a.
@DAS-Videos5 ай бұрын
I got mine on ebay www.ebay.com/itm/364833059230 90mm wide and 88mm between the bolt holes. 88mm and 90mm are just about the same size. I notice that the price dropped, I paid 250 for mine.
@randywilson68698 ай бұрын
I like it. Have you seen the 1 like that but with notches on the back side so as your curl your thing (brain fart lol) it would cut the roots. On the big excavator it was used to rip the stump . I think it was under search the rooster stump removal . Best 1 I have ever watched on utube
@DAS-Videos8 ай бұрын
I saw the one sold by Bxpanded that had the teeth. I didn't think it would fit my machine so I went with this one, made for these inexpensive minis. I like it. I did get the stump out today, I cut it into quarters and hammered wedges in between the sections that the mini could handle. It was a lot of manual work though.
@VaJamieАй бұрын
What size socket did you use on those bucket nuts? I'm expecting my QH12 machine any day now.
@DAS-VideosАй бұрын
35mm. NAPA Axle Spindle Nut Socket 35 mm to be specific.
@VaJamieАй бұрын
@@DAS-Videos Thank you sir. Much appreciated.
@HeavyDemir2 ай бұрын
did it come from China that smoot on the boom lift? mine jumps the entire machine unless I am ultra carefull when pulling back the stick. Also - quick attach is nice :D
@DAS-Videos2 ай бұрын
Yes, the ripper attachment came from China. The trick to not get bucked around too much is to have the ripper close to the machine, have the arm going straight down perpendicular to the ground and curl the ripper upward and pull the boom back.
@delcasaleexcavating95083 ай бұрын
Did you call NJ 1 call for utility mark outs ? Its the law !!! 😂😂😂😂
@DAS-Videos3 ай бұрын
😳
@brianmcgill73148 ай бұрын
It sounds like a lawnmower/power washer 😮
@DAS-Videos8 ай бұрын
It has a Briggs and Stratton engine in it, basically a lawnmower engine.
@delcasaleexcavating95083 ай бұрын
Hahaha I have a stump for you to dig out its only 48" diameter oak
@DAS-Videos3 ай бұрын
Wow. My limit for a green stump is about 10"" :-) Your machine can probably dig that oak stump out no problem.