Whelen Edge 96 series

Whelen Edge 96 series lightbar with built in traffic advisor

[@jrg6809]

Extremely bright bar! Still works 100% i see. Very nice!

[@rjracing38]

Thanks, thanks for watching.

[@tacomabanga1986]

Well mine is a 12 strobe, and don't know the config for flashers

[@tacomabanga1986]

I have one of these bars Where is the board so I can try and get the flashers working on mine?

[@rjracing38]

tacomabanga1986, usually the boards are set inside. Mine was located on the backside but yours may be the same. Best bet would be to unscrew the end caps off, the top panel then you'll have to slide out each lighthead out to pull the top portion out as long as yours doesn't have the I-Beam construction which basically means the aluminum frame is an 'I' which will have cut-outs in the center to allow wires to pass front to back...