Anyone else every have issues with the yolk bending while trying to press the factory u joints out? I had that issues numerous times. I now have a piece of steel stock that I put between the forks of the yolk so the don’t bend in when pressing the u joint out.
@frankyalvarez71604 жыл бұрын
I love how his just slides halfway in there while I’m over here with a fricking vise and a dremel cutting 1.5mm of steel away from the axles to have a chance on my u-joints being forced in. I’ve ordered multiple sets for an 08 Polaris 800 rzr and all of them are larger than the original.
@kevinfoster23083 жыл бұрын
I use an impact gun with every threaded press or pulling tool I have. No problems so far.
@robertsrbell78112 жыл бұрын
2021 hisun utv outfitter front drive shaft you have to remove the ujoint in the ride to get the shaft out will this tool work ty.
@paulgarcia62573 жыл бұрын
Found out price of new u Joints plus labor is more that just a whole new drive shaft with new ujoints 👍🤷🏽♂️
@miloradmedunic62029 ай бұрын
agree, 200 for entire assembly or 300 for replacement parts +labor+ press+ BEER+ BANDAIDS+ and thaaaaaan
@cryptocowboy22504 жыл бұрын
Ordered a press. Video very helpful thanks ;))
@terrellscaife24113 жыл бұрын
So can you just use a ball joint press
@TomofAllTrades4 жыл бұрын
Thanks for sharing. Great video
@mikealtemus4554 жыл бұрын
Any words of wisdom for someone who managed to pop one of the caps the whole way through into the inside of the yoke? I can’t get it lined up good enough to get it started to push back through the hole
@julietjuchnewich97104 жыл бұрын
i just did the same. used a 5" cutting wheel on a grinder to buzz it off. Worked fine
@lizstevenson46594 жыл бұрын
The u joint wont go in far enough to allow access to fit the clips. Any ideas
@georgevaneerden8772 ай бұрын
Get a Tiger Tool U Joint kit, much easier
@corissan86484 жыл бұрын
can we watch you put it on the atv?!
@vinayakmudakavi22435 жыл бұрын
Bro if hammer the press tool the threading may get damage We can even use small hydraulic press
@dunerinaz4 жыл бұрын
The plate is free floating so there's no pressure on the threads
@fredericbouchard-muller24154 жыл бұрын
clear video
@chriswilliams2652Ай бұрын
How the hell you get the damn thing out the machine? Why don't any of y'all show that?