ROADSTER SHOP CHASSIS FACTORY TOUR BUILD AND DESIGN

[@maristoldboys5466]

Lovely 2 part video series on the Roadster Shop chassis line. Best wishes and respect from Fiji.

[@RanasRadar]

Thank you so much and welcome!

[@MatsKarlsson-kl7ws]

Thanks Rana and Roadster Shop for a interesting video.

[@RanasRadar]

Welcome Mats, I hope the audio wasn’t too bad as it was very noisy, I do hope to go out again next year for another tour.

[@garryswann8255]

Very informative and eye opening video on how they make there chassis

[@RanasRadar]

I did my best as it was quite noisy there, but the boys were great

[@kenhodges6970]

......great vid....thanks rana...jerry;s 67 shelby is looking good and at the end phase...could be a good vid if you hear from jerry h....thanks rana

[@tsmatthx2]

How much does the chassis way on average? Looks heavy :)

[@SolveFixBuild]

Frickin’ loud in there! I can’t believe they literally grind every inch of the chassis. Might look into a beadblast or laser ablation finishing step to save labor and possibly cost. I did some work for Clevite bearings back in the day and they spent $1200/day on flap disks polishing the coil after the Sn/Pb coating. We priced out a $700k laser ablation machine that would do the same job and had a 2 yr payback then profit thereafter.

[@johnhagerty7998]

What size MiG wire do you use to make the frame rails, Frame rails 10 gauge thickness? Thanks