Roller follower cam design in solidworks

[@ShreddySteve]

Just a general design tip, when drawing in any CAD package, try to fully define your sketches so that no lines are blue. It helps lower the probability of making a mistake due to geometry that jumps when lines are moved.

[@physicscadssimulations9038]

Thank you... will do in the future inshaaaallah

[@ShreddySteve]

Pleasure!

[@surinderdhiman]

It would be very useful if you make a tutorial on a steel bar parting machine cam with 20 mm constant rise in 270 degrees at the equal rise in each degree. Overall this is also a very good video.

[@vsurendran6685]

thank you.... this video is very useful and I request you to teach how to design globoidal cam and barrel cam

[@redhaalsultan4817]

thank you very much ... this video is very helpful to me

[@Jean-vz8co]

The diagram at 22:30 is a bit good!!!!!!!!!!!!!!!!!!......................and well done!!!... by

[@redhaalsultan4817]

Also , can you put another video about how to get the graghs of velocity , acceleration and jerk using solidworks

[@physicscadssimulations9038]

the video already got very big.Inshaaallah will try to add in another video with simulation.thanks for the suggestion anyway

[@ariamehr9228]

Persian?

[@rx0788]

Walaykom Salam

[@yourjwave]