Roughing a Part with Opti Rough - Getting Started with Mastercam Mill Webinar 7/12

[@Aaron2Wheels]

So I followed your steps and got a good tool path. Only problem is I ha to flip my part to mill out other side and this tool path i made is cutting entire stock and itll run into jaws. It is also cutting through the pockets of my part. Any tips?

[@MLCCADSystems]

Check out the full webinar: kzbin.info/www/bejne/faauo6ODmp5qoLs on how to setup the second operation without messing up the first set of toolpaths. kzbin.info/www/bejne/Y5fHkJWurqmce8k