RSX fuel return line DIY on the cheap! Part 2

[@jmont124]

Nice video man

[@camlobesvtec]

I may have to do this in the future. I'm using the stock feed line for my feed and my return is just dumping in the tank. I have fuel starvation at a little less than a quarter of a tank.

[@markmlinar1511]

I set up very close to this and get starvation under half a tank. Since it works to half I know it's not pump size, (walbro 255, 1000cc E85,) but it's something. The previous didn't even run a return inside and put holes all over the basket. I got a new basket and ran the recomended return like you, but no luck. Back to the drawing board.

[@ricardobolanos2425]

Any luck?

[@Jyaj09]

im in the middle of doing mines.. did u just remove the fuel regulator or did u have to do something else too

[@Cloneufc]

You can see in the video I'm not using the stock fuel regulator at all. If you are turbo or you are running an upgraded fuel pump, do NOT use the stock FPR. I'm using an Aeromotive FPR that is 1:1 for boost that is located at the end of my return line near the fuel rail.

[@Jyaj09]

As long as i have a FPR that is running after the fuel rail i should be good right

[@Cloneufc]

You bypass it. You can remove it and just leave the plastic cage in. I left the plastic cage in because it has wires. Just copy how I have it. The hose goes from the return to the return jet. Just watch the video @2:10.

[@Jyaj09]

@@Cloneufc ok got it Thanks a WHOLE bunch !