very hidden informative knowledge share by u.. dear,keep it up....👍👍👍👍👍
@Ronduck73 ай бұрын
Bahut Bhadiya Bhai 👌
@rannvijaysingh111 ай бұрын
Bhai continue I like your content.
@bheemsinghverma5141 Жыл бұрын
Good
@VasudevSingh97 Жыл бұрын
🙂
@manjeetsinghrathore661523 күн бұрын
Bro 2 nd rule wrong hai Nine nhi h seven points hain .
@himanshuverma179615 күн бұрын
Ryt sir
@VasudevSingh9711 күн бұрын
Hi Manjeet ji... Good point h.... See, as I told at the end of video generally industries are following only starting three rules in SPC. But again they are using by modifying as per suitability. As you are saying for rule no 2 seven points using, so it is only in your industry but standard rule says for 9 points. And for rule no 3 also standard rule says for 6 points but industry is using with 7 points. As per standard Rule 1- Single point out of +/- 3 std Rule 2- 9 points continuously same side of center line Rule 3- 6 points continuously increasing or decreasing But in industry Rule 1- Single point out of +/- 3 std Rule 2- 7 points continuously same side of center line Rule 3- 7 points continuously increasing or decreasing Is there any further query then contact me on WhatsApp. +91 8191046829
@VasudevSingh9711 күн бұрын
Hi Himanshu, See, as I told at the end of video generally industries are following only starting three rules in SPC. But again they are using by modifying as per suitability. As per standard Rule 1- Single point out of +/- 3 std Rule 2- 9 points continuously same side of center line Rule 3- 6 points continuously increasing or decreasing But in industry Rule 1- Single point out of +/- 3 std Rule 2- 7 points continuously same side of center line Rule 3- 7 points continuously increasing or decreasing If there is any further query then contact me on WhatsApp. +91 8191046829