RXT X 300 DS18 Sound System

This is my series of my DS18 audio install on my 2021 Sea-Doo RXT X 300. This is a 3 part video. I try to explain my install and the final results. If you like the content please hit the like and subtribe button. Please leave you comments and I will respond. Below are the links of the products I used. Thank you!!
DS18-Source & Speakers
ds18.com/colle...
ds18.com/colle...
hifonics.com/s...

[@skylarsampson9318]

Or maybe an entire parts link? I would like to purchase the same exact set up. Sounds nice

[@sidsection]

Which wires on the factory harness were your remote and signal wires?

[@Whatnissan]

So volume doesn’t work on your phone with that controller ?

[@skylarsampson9318]

Where did you get the speaker pods? Can you send a link for speaker hardware?

[@rickacosta4061]

Tha ks for this video it was alot of help but I still have some questions. 1.Can you still control the volume on the stock handle bar controls? 2. I was thinking to leave the stock headunit in mine would that be a problem? 3. Did you run the power wires for the amp directly to the battery?

[@banuelos012690]

I left my stock amp in. And no issues at all.

[@jakestrader9533]

Parts list???

[@drkudos423]

Did you use 2 amps or both bridged to that one amp?

[@peterreca8137]

The Thor amp is a 2 channel amp

[@banuelos012690]

Did you just disconnect the amp and there was no issues? The screen didnt say hey where is my radio or and check engine lights or electrical problems?

[@seariders5728]

I disconnect the amp and used the same wiring to add the aftermarket one. No, I have the wire diagrams from the service manual. Everything works fine. Sound much louder than factory!