Rzr 800 Pinion Nut + More Upgrades = Lost Footage

[@anthonymendoza3103]

Hey man I just ordered a new rear diff for my 800s. How much would you charge to put some loctite and tighten it again? Or any permanent fix for it?

[@BradFFA]

hey buddy where are you located im in kentucky im scared my pinion nut is loose in my 2010 rzr 800s

[@driftbooster]

Hey buddy how has that gasket for the clutch box worked for ya as far as keeping water out and sealing it up in deep mud and ur just using not right now silicone with it

[@Randomalia]

Did you pull the diff straight out the back....or the side?

[@badlandsaerial8221]

What parts for the tool for the pinion nut. Specs please need to build one. I'm from Alberta.

[@tiberiuculda171]

do you rent out youre tools ?? interested in it renting them willing to pay for shipping 2 .. im in ontario canada

[@concealit4800]

I got a 14 rzr s that the motor mounts went bad but idk if that is related to the problem I'm having. Which is it went from being able to run about 60 to banging the rev limiter hoping out about 40 mph I replaced the primary and secondary clutch new belt.. We even put blue lock tight on the primary shaft.. We are lost?? Does the pinion nut cause the gearing to be throwed off when it back s off? We changed trans and transfer fluid and it was pretty clean very little black residue looks normal wear..

[@concealit4800]

If u ever heard of a rzr s doing aomething similar share ideas please I know u do alot with them

[@jasonmalone5185]

I just realized who ya were when you showed off the old king quad sticker hahaha

[@Solitude313]

Been around a minute.. cant get out of it and no plans to haha

[@robfannin8225]

Do you have the footage of the work you did in the trans on welding the shafts in it?

[@georgeduckworth4452]

How'd you figure out the torque for that pinion nut with the 16inch bar?

[@Solitude313]

There's a formula to follow to get your Torque spec based on a couple different parts

[@hardr7194]

You think you could help me, my ranger 700 Boggs out at full throttle won’t even spin a wheel in low gear.

[@Solitude313]

Id start with the Belt and then move to Fuel Pump

[@juanguerrero261]

Do you rebuild front diffs on rzr800 I heard it’s to hard and just want it done right

[@Solitude313]

I can if your close and you want to bring the diff to me.

[@obspowerstroke1864]

We’re did you get those tools to tighten the pinion nut?

[@Solitude313]

They were custom made from Swamp Donkey here on KZbin

[@huntermorse5520]

Diff seal kit link?

[@josephlantz979]

What year is your rzr

[@jmvalenciacazarez9895]

Yo ocupó uno para un rzr 800 2011