SAAB 9-5 AERO (1998-2010) OIL PRESSURE SENSOR HOME MADE TOOL

[@ajitbhakta7723]

Creative homemade solution, thank you for tht ...often at home we have to improvise , we normally not blessed with a large comprehensive tool chest ...

[@dlopezmxdf]

Just use a 24mm 12 point long socket and the wire will fit through any point of the socket. I've done this numerous times.

[@loumnar54]

You are not showing where the sensor is located. I have to change mine.

[@loumnar54]

@Derek Anthony Farmer I found it in the mean time but can't really access the 2nd nut around the starter as this pressure switch is between the Starter and the block , don't even feel the shape of a nut in the back... looks actually like a hard job just because of that. removing the switch would be strait forward if the starter was removed. Not sure that is the problem anyways as it is not leaking from there and has been changed 2 years ago.

[@e.h.p.]

apologees for not seeing your posts earlier, i do hope your issue has been fixed by now.@@loumnar54

[@rhobinhansen611]

Way do so mutch work i just remove all things around and you see how mutch pressure you need to use its finisch no problem becouse use the hammer its damage the sensor first and second when you put the new sensor back again.

[@e.h.p.]

Thank you for your contribution , but i say tap it,....not 'hammer' in the video. the tool is just used to crack it loose so you can use your hand to remove the old and place in the new then tap it after you get it hand tight to tighten it beyond hand tight. no need to remove any other parts at all.

[@John-oi8mt]

Firstly, good luck with swinging a hammer (no matter how small) in the tight confines of 9/5 engine bay! Second, why oil and filter change? Unless it’s due, of course!