SAITEK Control Panel - Switch repair

[@markellis789]

I have constantly had problems with these knobs binding up on me. Not only the multi-panel as shown here but I was also having problems with the engine switch binding on the Saitek switch panel. This fix worked perfectly for both of these. I can't believe how simple it was. Thanks Mark

[@cabewow6331]

Thank you sir! You should post this on the forums. I have seen a lot of people asking for solutions, and your video would calm a lot of nerves.

[@opensky1959]

Brilliant - still works like a charm in less than a minute - thank you very much.

[@frutigd]

Super, is a very big help and worked perfectly! Great thanks

[@philipjones3093]

This is the correct method . My control switch sized up till I could not turn it. a half second spray of WD40 and it is back to normal. all this can be done without removing the panel from the cockpit.

[@RiverSkyHigh]

It worked! And I was just about to try opening the entire panel...

[@bagoasm2202]

Thank you sir!

[@TheRyma52]

That's it. I've been looking for that. Thank you.

[@paultyler5989]

Thanks....That worked Great..... :)

[@brenoaugustoconsuli6964]

Thanks man.

[@allsizons5228]

My switch panel once connected to power landing gear lights blinks once then off i.e does not get connected to power. Any advice please?

[@upjohn5548]

Silver knobs can get off too¿

[@EduardoMCfly]

Will this work with wd40?

[@jirikocman]

great I did it with olive oil :) thanks

[@eizboks3975]

Olive oil will become sticky

[@pito2531]

thank Bro it fix my

[@allsizons5228]

My switch panel once connected to power landing gear lights blinks once then off i.e does not get connected to power. Any advice please?

[@allsizons5228]

My switch panel once connected to power landing gear lights blinks once then off i.e does not get connected to power. Any advice please?

[@allsizons5228]

My switch panel once connected to power landing gear lights blinks once then off i.e does not get connected to power. Any advice please?