Sample Thermwood Maintenance Video HSD Cartridge Removal

[@jubeikibagami7130]

Cuanto el control arroja una alarma de; sujetador pierde señal, el spindle no podrá arrancar. Cuál podría ser el problema o la solución?

[@MAbid-zt7nm]

my question about the atc spindle es929 which is that I am using one cutting tool most of the time means not required tool change often. so closed the air supply to the machine/ spindle to save the air compressor running continue . As i know that cooling is done by the cooling fan. so the air is for tool change and internal cleaning. as i mentioned go for tool change rarely. will closing the air to machine will make any issue to the spindle? i am asking because just reading the manual i find this which is below. ( The cylinders of these electro spindles are double-acting: it is necessary to keep the cylinder under pressure to maintain the piston at the upper end stop, far from the fast rotating parts. )

[@joefox1363]

Thanks for video. I have my spindle torn down to the same point as the video. The top steel bearings were bad. Now how do I break down the cartridge to remove the bearings? The ceramic bearings in the nose feel fine but my rebuild kit has a full set so I plan on changing them all. I just need some guidance on removing the bearings.

[@jorgetoledolordvader]

Excelente, lo voy a hacer

[@hakanaksakal9488]

İletişim numarası alabilirmiyim