Sometimes reball also success, But better to change ic.
@mohamadhafizabdrahman4541 Жыл бұрын
@@hellopj6518f i want to change the ic, what temperature set on hot air blower to remove the ic
@al-saadatmobiles87952 жыл бұрын
hi wich microscope you are using?
@hellopj65182 жыл бұрын
RF-7050TVW
@DulgenukChannel2 жыл бұрын
what componen you check 4.4?
@hellopj65182 жыл бұрын
That’s not component, that is battery connector on board
@DulgenukChannel2 жыл бұрын
@@hellopj6518 so why you check beside the ic charging and say 4.4?
@DulgenukChannel2 жыл бұрын
@@hellopj6518 i have check it on schematic that was vbus input, i have same condition, vbus have good but output to battery conector thats doesnt have volt, so thats make fake charging
@hellopj65182 жыл бұрын
Bro one’s watch video again, that component line was showing 0.92, actually value of that line 4.0 above. 0.92 means short in ic, or any components we have to check which one is short, I removed ic then I check value is get 4.4 that means ic short.