Thermostat Controller W1209 for Incubators

W1209 module is widely used in Incubators to maintain a temperature of 38.5 deg celcius to Hatch Eggs.
This video walks you through the settings to be done .
For incubator P0 setting is done to H Hot condition, where the relay is ON till temperature reaches the setting 38.5 deg C.
C cold condition is also explained where a DC Fan is switched on at a Set temperature.
www.alselectro....
video in Tamil :
• Thermostat W1209 Setti...

[@ashishpaulgeorge1981]

Hi, I tried to make an incubator with the same settings. But the bulb is not working. When i give the wires direct the bulb is burning, i tried the same wiring and did all combinations but the bulb not burning when connected to w1209

[@stanley1591]

Hey! I enjoyed watching your video, and happen to be working on the same. How would you go about connecting both the bulb and the DC12v fan in the same circuit? In essence they would operate in sync when on, the fan distributing heat from the bulb throughout the incubator space. Thoughts?

[@NightFury1680]

Sir our incubator is showing LLL and it stopped working what shall i do??

[@georgebreckenridge3351]

Good overview thank you !

[@hananben415]

Thank you very much sir!

[@lalrinkima7809]

👍👍👍

[@kashif8704]

I like the way you explain things. Doing good job.,,,

[@sayantanmaiti2513]

whats the microcontroller used here?

[@electronic7979]

👍

[@kadhiravank4210]

It will used for Cold storage devices? Reqd temp like as 0°c to -10°c. Is possible to set this .

[@vai.jagadeesan]

Super.... annaa👍✌

[@nava-kit]

nicely explained

[@shairalamkhan1102]

Bhai mery thermost ka H option kam nae kr raha .?? Jasey hi h option lagata hu tak tak karna shuru kr deta ha plz plz guide !!

[@vijayakumardnair6299]

Why the alarm light is on and the device not working?

[@varaprasadmummaleti4224]

Hi sir I have one doubt can I ask