Schneider ATV312 "Modbus RTU" Weintek MT8071iE Tutorial

[@punishedgoy9131]

How is the PLC connected ? Where is the HMI logic coming from ?

[@АртемПешин]

First you need to reset the device to factory settings. Since there may be settings that will prevent the device from being allowed to work in modbus mode.

[@asengsaputra288]

Hellor sir,and how can you also control digital input start and stop and can also control modbus communication Thank you

[@plc247automation6]

need read ATV312 Inverter Manual sir

[@hieupham-ff6kw]

How can I display negative Frequency in HMI? Please teach me the setting for Numeric Object in Easybuilder Pro?

[@TriNguyen-po9zl]

hi, how to connect modbus hmi mt6071 and atv310 inverter?

[@stevenalexandervelandiaare5874]

Hello if you use an atv320 the configurations are the same? I need to control the frecuency by modbus but the run and stop by the DI of the VFD

[@haloblade2472]

Can someone please tell how to wire it since I don’t understand the wiring diagram and I’m losing my mind

[@andre65043]

faca um video com atv310 ihm weintek

[@NoName-ut9wd]

what is adsress for forward, revers and stop ???

[@linhtranquang8490]

Set 8502(hex) = 15 >>> Forward Run Set 8502(hex) = 2063 >>> Reverse Run Set 8502(hex) = 4111 >>> Stop

[@NoName-ut9wd]

@@linhtranquang8490 thanks

[@ФилиппЛюблин-д4ъ]

@@linhtranquang8490 Please explain how such numbers were written to these registers?

[@edoardomichelazzo6767]

But can work also with the simulator?

[@plc247automation6]

If you have "USB to RS485" Cable

[@ИгорьОнищук-м1е]

When change # screen, modbus SLF1 altivar ...

[@lijamv6760]

you need to find "plc control" in your HMI and put some adresses of your device (in this case ATV12) in it so HMI and ATV can communicate when you escape in other screen, or the another way (which is not good) is to turn off modbus timeout protection in ATV12. also you can check communication in atv 12 just go in MON-NAi-CoN1

[@firdausalam1901]

Instead of this music - you could have explained it in the video.

[@sawinsrisawat2539]

มองไม่เห็น